Need help?Do you have a question about the BIG TREE TECH S42C and is the answer not in the manual?
Configuration options available through the OLED menu for various settings.
Defines the data structure for reading registers via UART.
Defines the data structure for writing registers via UART.
Lists registers for configuring parameters like Baud rate, Current, and Step mode.
Lists registers for reading status like current value, micro step, and mode.
Table correlating microsteps with pulse numbers for a full 1.8° stepper cycle.
Provides important advice for installation, calibration, and operation of the S42C driver.
General| Signal Voltage | 3.3V |
|---|---|
| Operating Voltage | 3.3V |
| Microstepping | Up to 1/256 |
| Interface | UART |
| Communication Interfaces | UART |
To Next Page
