Need help?Do you have a question about the BigJoe E30 Series and is the answer not in the manual?
General| Frequency | 50/60Hz |
|---|---|
| Operating Temperature | 0°C to 40°C |
| Model | E30 Series |
| Category | Test Equipment |
| Type | Electronic Load |
| Voltage Range | 0-150V |
| Current Range | 0-30A |
| Power Output | 300W |
| Display | LCD |
| Protections | Over Voltage, Over Current, Over Temperature, Reverse Polarity |
| Interface | RS232 |
Lists the essential tools needed for conducting charger tests, including electrical meters and connecting accessories.
Details the steps for performing an amperage draw test on the charger, including disconnecting wires and connecting the meter.
Explains how to set up and conduct a voltage test on the charger, including connecting jumper wires to battery terminals.
Describes how to confirm charger operability by observing amperage and voltage changes during testing.
To Next Page