Biktrix 500S - Assist Levels Configuration; Number of PAS Levels; Error Code Definitions; Error Code Meanings

Assist Levels
Display will show PA. Press the UP and DOWN buttons to change the number of PAS
levels the bike will have. This can be set as 0-3 (3 levels), 0-5 (5 levels) or 0-9 (9
levels). Press the MODE button to save changes and return to the SYSTEM parameter.
Error Code Definitions
The 500C display can show error warning messages. An engine icon will be
displayed on the screen and the error code will be displayed at the bottom of the
screen. For specific definition of the error codes consult the table below. If you need
assistance in resolving these errors, please contact Biktrix support.
Error Code
Error Description
Error Display
0x01
Normal
No error
0x03
Brake Signal
No error
0x04
Throttle in high position
Display 04H on speed position
0x06
Low voltage protection
Display 06H on speed position
0x07
High voltage protection
Display 07H on speed position
0x08
Motor hall sensor error
Display 08H on speed position
0x09
Motor phase line error
Display 09H on speed position
0x10
Controller high temperature
Display 10H on speed position
0x11
Motor high temperature
Display 11H on speed position
0x12
Current sensor error
Display 12H on speed position
0x13
Battery temperature sensor error
Display 13H on speed position
0x14
Motor temperature sensor error
Display 14H on speed position
0x21
Speed sensor error
Display 21H on speed position
0x22
BMS communication error
Display 22H on speed position
0x30
Communication error
Display 30H on speed position