(6) “SOC View” --- set display mode for battery capacity
Select “SOC View” in the “Display Setting” interface. Once selected, press the LEVEL+ or
LEVEL- buttons to switch display mode for battery level as “Percent” or “Voltage”. After
selecting your preferred State of Charge view, press the MENU button again to save the
setting and exit back to the “Display Setting” interface.
(7) “TRIP Reset” - reset function for single-trip distance
Select “TRIP Reset” in the “Display Setting” interface. Once selected, press the LEVEL+ or
LEVEL- buttons to switch between “NO” and “YES”. TRIP Reset will reset the maximum
speed (MAXS), average speed (AVG), single-trip distance (TRIP) values. After performing this
action, briefly press the MENU button again to save the setting and exit back to the “Display
Setting” interface.
(8) “Wheel” - set the wheel diameter
This setting will not need to be changes unless you are changing the wheel size on your bike.
If you are changing wheel sizes, select “Wheel” in the “Display Setting” interface. Once
selected, press the LEVEL+ or LEVEL- buttons to select the wheel diameter as
“6/7/8/…/32/33/34”. After selecting your bike’s wheel diameter, press the MENU button again
to save the setting and exit back to the “Display Setting” interface.
To Next Page
Loading...
Need help?
General
