Billi Alpine - Filter Removal and Replacement Instructions

8
User guide
Billi Alpine.
Filter removal and
replacement instructions
Important note: Please ensure you remove the
foam packing under the filter before installing.
1. Remove the front panel.
2. Place the unit in Holiday Mode by
pressing the Pressure Relief button once.
The lights on the dispenser will alternate
and then go o
3. Hold filter and swing towards you slowly.
The top of the filter is in a hinged cradle
assembly. It should stop after approximately
30 degrees of travel.
4. The filter can now be released from the
holding cradle by pulling down on the filter.
5. Take care not to spill water in the base of the
tray. If so wipe gently with absorbent paper.
6. Install new filter into the same location
by pushing all the way up into the cradle.
7. Push filter back into the unit until it locks
into place. Power light should come back on.
8. Lift cold lever for the levered style taps
or touch and hold the blue icon for the
touch activated taps and run until water
flow stops. Close cold lever, or remove
your finger from the blue icon and wait
for 10 minutes.
Lift cold lever or touch and hold again and
run until water stops. Close cold lever or
remove your finger from the blue icon.
9. Check for any leaks from around the
filter, hosing or pipeworks.
10. Replace the front cover.