Billy Goat HW650SP User Manual (English)

Questions and Answers:

M
Michael LongAug 15, 2025
How to fix a Billy Goat HW650SP that will not start?
- A
  Angela RodriguezAug 15, 2025
  If your Billy Goat Lawn Mower engine won't start, there are several potential causes: * The operator presence control bail might not be engaged. Ensure it is engaged. * The engine may not be properly primed. Prime it to choke. * There might be no gasoline, or the gasoline is old or bad. Check the gasoline. * The spark plug wire could be disconnected. Check for a spark with an approved tester. * The air cleaner might be dirty. Clean or replace the air cleaner. * The blade might be trying to cut grass while starting. Start the mower on pavement or a previously cut area.
V
vasquezscottAug 18, 2025
What to do if my Billy Goat HW650SP Lawn Mower will not cut properly?
- T
  Todd PattersonAug 18, 2025
  If your Billy Goat Lawn Mower is not cutting well, several factors could be responsible: * The blade may be dull or bent. Sharpen or replace the blade. * The deck might be clogged. Unclog the deck. * The engine may be running at too low RPM. Check the engine RPM. * The grass could be wet. Avoid mowing when the grass is wet; wait until it's dry. * The grass might be excessively high. Mow once at a high cutting height, then again at the desired height, or make a narrower cutting path.
C
Christine GriffithAug 21, 2025
Why does my Billy Goat Lawn Mower engine run poorly?
- J
  Julia HuertaAug 21, 2025
  If your Billy Goat Lawn Mower engine runs poorly, consider these potential causes: * A loose spark plug wire could be the issue. * The engine RPM might be set too low. * The carburetor may be out of adjustment. * There might be water or dirt in the fuel system. Drain or siphon the fuel and replace it with fresh gasoline. * The spark plug could be fouled, faulty, or have the wrong gap. Reset the gap or replace the spark plug.
S
salazarjasonAug 25, 2025
Why is my Billy Goat HW650SP Lawn Mower vibrating so much?
- S
  Scott HernandezAug 25, 2025
  If your Billy Goat Lawn Mower is vibrating abnormally, here are a few things to check: * The blade might be loose or out of balance. Check the blade mount and balance, and replace if necessary. * The blade could be bent. Replace it with a new blade. * The engine might be loose. Check the engine mount.
B
bradley04Aug 27, 2025
How to fix an uneven cut with my Billy Goat HW650SP?
- H
  Heather DavisAug 27, 2025
  If your Billy Goat Lawn Mower is producing an uneven cut, it could be due to: * Incorrect height adjustment. Ensure the height adjust is set the same on both sides. * A dull or bent blade. Sharpen or replace the blade.
B
bendercarolineAug 30, 2025
What to do if my Billy Goat Lawn Mower engine will not stop?
- J
  Jonathan RobinsonAug 30, 2025
  If your Billy Goat Lawn Mower engine will not stop, it may be due to: * A damaged operator presence control bail. Replace the operator presence control bail. * A damaged control cable. Replace the control cable.
C
Catherine CalderonSep 2, 2025
Why won't the self-propelled drive release on my Billy Goat HW650SP Lawn Mower?
- D
  Daniel BellSep 2, 2025
  If the self-propelled drive on your Billy Goat Lawn Mower won't release, it could be due to: * A clutch cable that is out of adjustment. Adjust the clutch cable. * A damaged operator presence control bail. Replace the operator presence control bail.
T
Thomas BarrSep 5, 2025
Why is the belt slipping or smoking on my Billy Goat Lawn Mower?
- A
  April LopezSep 5, 2025
  If your Billy Goat Lawn Mower belt slips or smokes, it could be due to: * Belt tension that is too low. Increase the tension at the idler. * A belt that is worn or stretched. Replace the belt. * Pulleys that are worn or damaged. Replace the pulleys.
K
Kelly NicholsonSep 8, 2025
What causes a Billy Goat HW650SP Lawn Mower engine to lock up?
- B
  Brittany DavisSep 8, 2025
  If your Billy Goat Lawn Mower engine is locked and will not pull over, it could be due to: * Debris locked against the blade. Remove the debris. * The operator presence control bail is not engaged. Engage the operator presence control bail. * A broken control cable. Replace the control cable.
L
Lisa GarrisonSep 12, 2025
Why is my Billy Goat Lawn Mower not self-propelling?
- J
  Jeremiah KempSep 12, 2025
  If your Billy Goat Lawn Mower is not self-propelling, it could be due to: * The gear not being set. Shift the lever to the desired gear. * The clutch cable being out of adjustment. Adjust the clutch cable. * A broken clutch cable. Replace it with a new cable. * A worn or broken belt. Replace the belt.