Billyoh EZE BASE User Manual

‘ EZE BASE’ INSTRUCTIONS
BillyOh.com – Grassthorpe Road – Sutton on Trent – Newark – Nottinghamshire – NG23 6QX – Tel. 0870 777 8891
THE BILLYOH EZE BASE
*Tape measure not included.
BUILDING ASSEMBLY
STEP BY STEP CONSTRUCTION OF YOUR PRESSURE TREATED EZE BASE
STEP 1: MEASURING YOUR SHED PRIOR TO ASSEMBLY OF ‘EZE BASE’
Measure the length of the building which is to be mounted on the Eze Base and transfer these dimensions to the
two outers supplied. Mark accordingly and trial fit with the floor of the building.
STEP 2: LAYING OUT ALL PARTS
Lay all parts of the Eze Base in their intended place as
demonstrated by the illustration (right). This is to ensure that
the stretchers can be placed equally apart as to support a
building most effectively and to check that all parts have been
received.
‘L’ bracket
Corner
anchors
Stretchers
Outer

Billyoh EZE BASE Specifications

General

Type	Shed Base
Color	Black
Weight	Varies by size
Assembly Required	Yes
Dimensions	Varies by model

Summary

BUILDING ASSEMBLY

STEP 1: MEASURING YOUR SHED PRIOR TO ASSEMBLY OF 'EZE BASE'

Measure shed dimensions and transfer to base outers for trial fit.

STEP 2: LAYING OUT ALL PARTS

Arrange all parts to ensure correct spacing and completeness.

STEP 3: NAILING OUTERS AND STRETCHERS TOGETHER

Securely nail stretchers into the ends of the outer frame pieces.

STEP 4: SQUARING OFF THE FRAMING

Measure diagonals to ensure the frame is perfectly square.

STEP 5: SCREWING ‘L' BRACKETS ONTO FRAME (OPTIONAL)

Attach 'L' brackets to level the base if the ground is uneven.

STEP 6: SCREWING THE CORNER ANCHORS TO THE CORNERS AND FIXING IN PLACE

Attach corner anchors and drive the base into the ground for stability.

OPTIONAL STEP 7: SCREWING ANY REMAINING 'L' BRACKETS TO THE OUTER CORNERS OF THE BASE

Use remaining 'L' brackets to further reinforce the outer corners of the base.

PRODUCT WARRANTY