Modes
Cool/dry/fan: each pressure of the “Mode” button selects the modes and the LED of the
selected function illuminates. During the switch between modes, the fan keeps operating
but the compressor stops and will restart after about 3 minutes. This delayed start protects
the compressor from potential damage. The extending pipe must always be connected to
the appliance, except when it is used in dry mode; in this case, the appliance should be
allowed to discharge straight into the room, for the maximum efficiency.
- Cool
The "Cool" light on the control panel comes on; select:
- the temperature: 16°C-31°C
- the fan speed (low/hi)
- Timer and Sleep function
If the On/Off button is pressed, the unit remains in stand-by and the appliance saves the
temperature and speed; when it is switched back on, it will maintain the settings made earlier.
To Next Page
Loading...
