carried
out
prior
to
returning
the
compressor
to the suppliers. Only
electric heating to the compressor body shall be employed to
accelerate this process.
When oil is drained from a system, it shall be carried out safely.
INSTALLATION
• After removing the packaging, check that the appliance is intact; if in doubt, do not use it
and contact a qualified professional. The packaging elements (plastic bags, polystyrene,
metal tacks, etc.) must not be left in reach of children or irresponsible people, as they can
be dangerous. They must be disposed of according to current regulations. All packaging
elements must be disposed of according to their raw material (see the symbol stamped
on each one) and according to the provisions of their municipality. The bag, which is
unmarked due to its small size, therefore you have to follow the procedures for the
disposal of their municipality.
• Before connecting the equipment, make certain that the plate information (voltage, etc.)
correspond to the characteristics of the electricity distribution network. This appliance
must be connected to a socket that has an effective earthing device (the manufacturer
declines any liability that may arise from failure to comply with this rule). Check that no
other appliances with a high energy consumption are connected to the power supply, to
avoid overloading and the risk of fire. In general, the use of adapters, multiple sockets
and/or extension leads is not recommended. If their use is unavoidable, they must comply
with current safety regulations and their current capacity (amperes) must be no lower
than the maximum current draw of the appliance.
• The appliance must be installed by skilled staff with the necessary technical qualifications,
who certify compliance with current installation standards.
• No responsibility is accepted for failure to comply with this requirement, or in case of
connection to a substandard electrical system. Incorrect installation may cause personal
injury, harm to pets or damage to property, for which the manufacturer cannot be held
responsible.
• The appliance must be installed and/or placed in a room at least 12m² in area.
• Do not use the appliance in:
- bathrooms, laundries, locations where there are flammable products (spray cans or cans
containing gases, liquids or solids, or sulphur) or dusty locations, or close to heat sources.
- premises containing other machinery which emits large amounts of heat
- near to a source of brine or sulphurous water
- locations with high humidity and with open doors or windows
To Next Page
Loading...
