USE
• Do not leave the air-conditioner in operation for long periods with high humidity and
open doors or windows. The humidity might condense, wetting or damaging furnishings.
• For optimal air-conditioning and heating efficiency, doors and windows must always be
closed.
• In: Cool, Heat or Fan modes, check that the drainage plugs are fitted correctly.
• If continuous drainage is in use, make sure that the drainage hose is properly connected
to the spout, that the opposite end is lower than the spout, and that the incline is even, so
that the water flows internally without any obstructions.
• Caution: do not cover the appliance to avoid overheating.
Before each use, make sure that:
-the appliance is in good condition
-that the power cable and flexible pipe are not damaged
• Connect the plug to the power socket; you will hear a beep.
•
Turn on the appliance, press the “POWER” button and activate the functions required,
proceeding as described above.
•
Press the “POWER” button to deactivate the appliance: it switches to stand-by mode. To
switch it off completely, the plug must be removed from the power socket.
Energy saving advice
• Always keep the filters clean, inspecting them regularly
• Keep doors and windows firmly closed except when the room needs airing
• Do not allow sunlight to shine straight into the room (use curtains, lower the roller blinds
or close the shutters)
• Do not obstruct the appliance's air inlet and outlet grilles
During long periods of inactivity, remove the plug from the electric socket.
CLEANING AND MAINTENANCE
Warning: disconnect the plug from the power socket before routine cleaning; the appliance
must remain vertical during cleaning.
• Filters
These should be cleaned regularly (at least about once a fortnight, or more often if the
appliance is in continual operation every day).
Air inlet filter
: remove the grille (B) using the handle, undo the 4 screws (A) with a
screwdriver and remove the filter.
Concealed filter
: extract the filter outwards using the handle “C”.
Remove dust with a brush or vacuum cleaner, taking care not to damage any part. If the
filter is very dirty, wash it in warm water and rinse it a few times. The water temperature
must not exceed 40 °C. After washing, leave it to dry fully before returning it to its proper
seat. Never wash in the dishwasher.
Dry it thoroughly (do not use hot air) then fit it correctly back in place.
To Next Page
Loading...
