Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
8
/
19
Assembly page 8/19
Fax +32 030 9904733
Fig.1 Fig.2 Fig.3
DESCRIPTION OF THE APPLIANCE
1) Selector Knob
2) Thermostat Knob
3) Light
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
The thermofan can be used for the only fan function or to heat.
To use the thermofan, please follow the instructions below:
1) Insert the plug in the current socket.
2) Turn the thermostat knob clockwise to the position corresponding to the desired temperature: in
pos. “-” the fan heater remains switched off in normal conditions, in the “+” position, the
thermostat is at maximum; the appliance operates continuously, while in the intermediate
positions, the element operates at intervals.
3) To switch the appliance on, turn the selector knob to the position corresponding to the desired
function:
“0” = off “
” = fan
“I” = air warm (1000W) “I I” = air very hot (2000W)
4) To turn off the appliance, turn the Knob in the “0” position.
5) After the use, plug out from the current socket.
To Next Page
Loading...
Need help?
General
