Bimar VD200 - Page 25

25
" " button (5): oscillation (right-left) is active when the unit is switched on. Press once to
activate (corresponding LED will be on) or deactivate (corresponding LED will be off).
Switch off the wifi function: press the oscillation button “ ” for 2 seconds: led from green colour
to blue colour (for about 1 second)
Switch on the wifi function: press the oscillation button “ ” for 10 seconds: led from green
colour to blue colour (for about 1 second)
Vertical inclination (high-low): is selected by directing the motor housing in the desired
direction (high-horizontal-low).
Led (3), during operation the red LED:
- is in a fixed position, but after about 1 minute an auto power off and power on again will be
activated at the first selection
- blinks: this indicates that the battery charge is below 25%. The unit will run for some time,
but it will then turn off. To charge it, see Battery description.
Autonomy (fully charged battery): if the fan runs at minimum speed it can run continuously
for up to a maximum of around 7/8 hours. If it runs at maximum speed it can run continuously
up to a maximum of around 2/3 hours. It is advisable to completely discharge the fan battery
to ensure a longer life.
Power bank function: the fan battery (first check the charge status) can be charged using
an electronic device (smartphone, tablet, etc.) via the USB port (2).