Bimar VTM33 - Page 14

14/40
1. Front
grill/protective
screen
2. Fan
3. Fan fixing screw
4. Rear grill fixing
screws
5. Rear grill
6. Motor shaft
7. Oscillation button
8. Housing
9. Clutch screw (tilt
up/down)
10. Switch
11. Cord
12. Screw with nut
1. Insert the rear grid (5) onto the motor shaft, so
that the handle is at the top (like in the figure to
the side), securing it using the 4 screws provided
(4.)
2. Insert fan (2) onto the motor shaft (6) and attach it so
that the screw (3) touches the milling formed on the
motor shaft (like in the figure), (at the end of the
work, check that the fan is correctly secured).