How to change CTCSS sub-channels on Binatone ACTION 950 Two-Way Radio?
To change CTCSS sub-channels on your Binatone Two-Way Radio, first ensure that the Key Lock mode is deactivated. If the Key lock icon is displayed on the LCD screen, deactivate it. Then, press the MENU button twice until the CTCSS sub-channel number flashes on the LCD screen. Finally, press the UP or DOWN button to change the CTCSS sub-channel.
What to do if Binatone ACTION 950 Two-Way Radio has sound distortion problems?
If you experience sound distortion with your Binatone Two-Way Radio, it could be due to several reasons. If transmitting, speak in a normal tone of voice, keeping about 5 cm away from the microphone. If receiving, lower the volume to a comfortable level. Ensure the radios are at least 2 meters apart, or increase the distance. Obstacles can also interfere with the transmission, or the radios may be too far apart.
Why is the range limited on my Binatone ACTION 950?
The range of your Binatone Two-Way Radio may be limited if the batteries are weak. If the charge level indicator is low, replace them with new batteries. Also, keep in mind that the maximum range can vary depending on the terrain and environment.
What to do if my Binatone ACTION 950 Two-Way Radio has no communication?
If your Binatone Two-Way Radio isn't communicating, check the channel and CTCSS code settings. Ensure both the transmitting and receiving units are tuned to the same channel and CTCSS code (if applicable).
How to fix weak reception on Binatone Two-Way Radio?
If you're experiencing weak reception on your Binatone Two-Way Radio, the receiving signal may be weak or out of range. Try turning the PWR/VOL button to increase the receiver volume level. If the problem persists, press the MENU and DOWN buttons simultaneously to activate the Monitor function.
Why Binatone ACTION 950 Two-Way Radio has no power?
If your Binatone Two-Way Radio has no power, check if the batteries are installed properly. Also, the battery may be weak, so try replacing the old batteries with new ones.
Explains the meaning of various symbols and icons displayed on the LCD screen.
Guides on how to detach and attach the belt clip to the radio unit.
Steps for inserting batteries and procedures for charging the radio.
Explains the battery level indicator and provides tips for battery conservation.
Details the radio's transmission range and important safety precautions during use.
Instructions on how to power the radio on and off using the power switch.
Guide on selecting main channels and configuring CTCSS/DCS sub-channels.
Explains how to receive signals, transmit voice, and use monitor functions.
Details on setting VOX sensitivity and other operational modes.
Guide on selecting call tones and activating the vibrator function.
Instructions for setting the Roger Beep and Key Tone ON or OFF.
Explains how to use Dual Watch mode and activate/deactivate the Key Lock feature.
Information on the LCD screen backlight and microphone/earphone jacks.
Details on channels, power output, and transmission range.
Lists available channels and their corresponding frequencies.
Covers warnings related to damaged antennas, batteries, and explosive atmospheres.
Guidelines on how to clean the device without causing damage.
Details on the warranty period, conditions, and repair process.
Provides solutions for common problems like no power, weak reception, and no communication.
General| Maximum range | 10000 m |
|---|---|
| Operating frequency | 446.00625 - 446.09375 MHz |
| Battery type | AAA |
| Rechargeable | Yes |
| Number of batteries supported | 4 |
To Next Page
