38
Warning
Specic Absorption Rate (SAR) information
SAR tests are conducted using standard operating
positions accepted by the FCC with the phone
transmitting at its highest certied power level in
all tested frequency bands, although the SAR is
determined at the highest certied power level, the
actual SAR level of the phone while operating can
be well below the maximum value, in general, the
closer you are to a wireless base station antenna,
the lower the power output.
Before a new model phone is a available for sale
to the public, it must be tested and certied to the
FCC that it does not exceed the exposure limit
established by the FCC, Tests for each phone are
performed in positions and locations (e.g. at the ear
and worn on the body)as required by the FCC.
For body worn operation, this model phone has
been tested and meets the FCC RF exposure
guidelines when used with an accessory designated
for this product or when used with an accessory that
contains no metal and that positions the handset a
minimum of 1.5 cm from the body.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation. Any Changes or
modications not expressly approved by the party
responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found
to comply with the limits for a Class B digital device,
To Next Page
Loading...
