15
www.bindicator.com
TDR180003 Rev. I
PROGRAMMING WITH THE DISPLAY
PROGRAMMING WITH THE DISPLAY UNIT
The most important parameters can be set with the display unit.
By default, the display shows the primary measurement result (from which the output current is calculated).
In addition to the measured value displayed in large numbers, a bar graph representing the value of the output
current is also shown on the right.
Programming is done using a text menu. You can use the E / / / buttons to navigate the menu.
Display Unit
Display
64 × 128 dot matrix LCD, signs, units and bar graph
Ambient temperature
–20…+65 °C (–4…+149 °F)
Housing material
PBT fiberglass, plastic (DuPont®)
Warning!
Display uses an LCD, do not expose to prolonged exposure to strong heat or sunlight as the display may be
damaged.
If the display cannot be protected against solar radiation or it is used outside the operating temperature range remove
the display during operation.
If you do not exit the menu, the device will automatically return to the measurement display state after 30 minutes. In
this case, any changes made in the menu will be ignored.
If the display is removed, the TDR3000 will automatically exit the menu and ignore any changes made in the menu.
To Next Page
Loading...