EasyManua.ls Logo

Bintelli Beyond - Radio Ports and Screen; Operational Guidelines; Safe Operation Instructions; Storing and Charging Procedures

Bintelli Beyond
17 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8. PAU
On USB/SD mode use to PLAY/PAUSE
9. INT
On USB/SD mode pressing it gives a 10-second preview function
10. RPT
On USB/SD mode used to switch over from REP1, REP ALBUM, and REP ALL
11. RDM
On USB/SD mode use for RDM mode
12. CLK
Clock, press SEEK + to adjust the hour, SEEK - to adjust the minute
*** Please note if you wish you set the time on your vehicle, it will be reset every time the cart is turned off
as the radio loses power every time the vehicle is turned off ***
13. MUT
Press to mute the sound, and press it again to recover the previous volume level
14. USB, 15. AUX, 16. Screen
Safe Operation Instructions
Our vehicles are designed for simple operations. However, please make sure to observe the following
safe operation instructions. As with any new vehicle, always familiarize yourself with its controls. As well
as perform checks on the battery, tires (recommended tire pressure is 30 psi), body/chassis, brakes,
parking brake, and steering prior to operating the vehicle.
Caution
Always ensure that the key is removed before performing any of the above checks.
Only authorized people should drive this vehicle, and from the driver’s side only.
Do not drive this vehicle on any public roads before it is registered and has the license plate
attached.
Only drive this vehicle where you are allowed by law or local regulations.
Do not overload the vehicle, otherwise, the motor may be damaged, or the vehicle will lose
control putting the driver and passengers in danger.
Do not operate the vehicle under the influence of alcohol or drugs.
Do not attempt to go uphill/slopes beyond its grade ability.
Do not pass other vehicles at crossroads, blind areas, or any dangerous conditions.
ALWAYS engage the parking brake when getting out of your vehicle.
Storing and Charging
If the vehicle needs to be stored for an extended period of time, perform the following actions:
Fully charge the battery system
Turn the “Tow/Run” switch to the “Tow” position.
Remove the key and keep it in a safe place.
Ensure each tire is reading 30 psi.