Bio-Tek FL600 ix
Contents
1. Introducing the Bio-Tek FL600
Hardware Requirements 1-3
Software Requirements 1-4
2. Getting Started
Setting Up the FL600 Reader 2-1
Installing KC4™ and FL600 Diagnostic Software 2-2
Installing KC4 2-2
Installing the Hardware Key 2-2
Installing the FL600 Diagnostic Software (Diagnostics Use)2-2
Checking the FL600 System 2-4
Using the FL600 Diagnostic Software 2-4
Filter Wavelength Locations 2-5
Checking the COM Port 2-5
Running System Diagnostics 2-7
What to Do if the Tests Fail 2-8
Exiting the FL600 Diagnostic Software 2-9
3. Replacing Filters and Adjusting Probe Height
Adding and Replacing Filters 3-1
Changing the Filters Inside the Reader 3-2
Setting the Filter Positions in KC4 Software 3-6
Utilizing the Filter Adapter System 3-7
Removing the Filter from the Adapter 3-7
Inserting the Replacement Filter into the Adapter 3-8
Adjusting Top Optical Probe Height 3-8
FL600 Interior Configuration Diagrams 3-10
4. Bio-Tek FL600 Maintenance
Maintaining the Reader 4-1
How to Maintain the Exterior 4-1
How to Replace the Air Filter 4-1
How to Replace the Lamp 4-3
To Next Page
Loading...