Bio-Tek FL600 - FL600 Filter and Probe Adjustments

&KDSWHU
5HSODFLQJ)LOWHUVDQG
$GMXVWLQJ3UREH+HLJKW
This chapter discusses how to add and replace filters and
adjust probe height for the FL600.
$GGLQJDQG5HSODFLQJ)LOWHUV
Adding new filters or replacing existing filter sets is a two-step process:
• Changing the excitation and emission or absorption filters in
the filter wheels inside the reader.
• Changing the settings to reflect the filter change in the KC4™.
The settings in the system software must correspond exactly to the
physical location and specification of the filters on the filter wheels. An
error in the system software specification for the filter could damage the
instrument and affect the FL600 warranty.