Wall Anchor Remote Control Bracket Screws Remote Control
1. Drill two 6mm holes on the wall that line up with the remote bracket.
2. Install the wall anchors in the newly drilled holes.
3. Place the remote bracket over the wall anchors.
4. Use the provided screws to attach the remote control bracket to the wall.
5. Place the remote control on the bracket.
REMOTE INSTALLATION GUIDE
3
Support: 847.458.2334
Dynamic
stream
Nozzle
forward
Nozzle
backward
Water
pressure
Water
pressure
Nozzle
clean
Night
light
Air
temp
Water
temp
Seat
temp
Open/Close
seat
Open/Close
lid
To Next Page
Loading...
