CONNECT WITH SUPPLIED POWER ADAPTER
Plug the DC plug of
the power supply into
the socket on the side
of the ElectroFlex.
Plug in the power adaptor to a suitable wall socket. (Make sure
that the input voltage of the wall socket is suitable for the sup-
plied adaptor.
INSTALLING THE BATTERIES
If you want to use the ElectroFlex with battery power instead of
the supplied main adapter, the battery compartment is located
On the under side of the unit.
Remove the battery cover from the unit. Insert three new 1.5V
size C batteries with the + and - marks correctly aligned.
Note on batteries:
Do not mix different types of batteries or an old battery with a
new one. To prevent the risk of leakage of explosions, never
recharge the batteries, apply heat or take them apart.
When not using batteries, remove them to prevent battery drain.
If liquid leaks from the batteries, throw them away. Thoroughly
clean the battery compartment with a dry cloth.
To Next Page
Loading...