Operation Quick Start
Bio-Fragment Analyzer: Qsep
1
Document No.: F0016
Ver.: ENG-F
Page: 1/3
1. Ensure the protecting foam is removed (Fig. 1 & 2).
2. Plug the power cord (labeled Qsep
1
) and Ethernet
cable (optional).
*Scan the QR code for instruction video.
4. Switch on Qsep
1
, the LED lights up (multiple color
light) (Fig. 3). Wait 25 seconds until the instrument
and Wi-Fi initialized, and the green LED will start
flashing (Fig. 4).
- Check if the AP source is available for Wi-Fi network
on the computer (Fig. 5).
- Find the SSID named with “Qsep1+instrument ID
(16 digits) ” and click “Connect” (Fig. 6).
- Enter the password:
The password will show in the sticker which is
behind the instrument. It is the same as the middle
8 digits of instrument serial number (same as SSID
name) without the prefix “Qsep1” (Fig. 7).
3. Connect the air tube.
*The green flashing LED shows the instrument is
ready to connect. If not, please repeat step 4.
Wi-Fi connection: follow the steps below to
connect with Qsep
1
Fig. 5
*DO NOT switch on the instrument immediately
after powering off. Wait at least 5 seconds.
Ethernet cable connection:
refer to step 5 on Page 2
Ethernet cable
Fig. 3
Fig. 6
*If the computer cannot find the Qsep
1
SSID, keep
the distance between Qsep
1
and the computer
within 10 meters and start from step 4 again.
*If the computer cannot connect with Qsep
1
,
- Check the Wi-Fi IP assignment is “Automatic
(DHCP)”
- Initiate the software as administrator
- Allow Q-Analyzer pass through firewall or turn
off the firewall
Fig. 4
Blue
Green
00923718
Fig. 7
Fig. 1
Fig. 2
To Next Page
Need help?
General
