BIOS LIVING SC427 User Manual

2 pages

To Next Page

Introduction

Thank you for purchasing the BIOS Living Digital Analog Scale. This scale was developed with state-of-the-art electronics. This precision

device has a weight capacity of 396 lbs / 180 kg and is equipped with an auto power ON / OFF function and auto zero reset.

Features

• Digital and analog displays • Auto ON / OFF

• Blue backlight display • Low battery and overload indicator

• Reminder alarm • Batteries included

• Accurate up to 396 lbs / 180 kg • 5 year warranty

Battery Installation

1. On the base of the scale, gently remove the battery cover.

2. Insert 3 x AAA batteries into the compartment observing the polarity markings. The LCD display will

turn on for 5 seconds then turn off. (See Figure 1).

3. After inserting the batteries, replace the battery cover.

4. Tap the center of the scale once to turn the scale on. The scale will go into calibration mode. Once

the calibration test is complete you will see on the display.

NOTE: Please be aware that inserting the batteries according to incorrect polarity

may cause permanent damage.

Unit Conversion

To change the unit LB / KG, switch the button located on the bottom of the scale.

(See Figure 2).

Using your Scale

1. Place the scale on a solid, level surface.

2.Gentlystepontotothescaleandtheunitwillautomaticallyturnon.Onceasteadyreadingistaken,thedisplaywillash3timesand

will display the weight.

3. The weight will stay on the screen for 5 seconds once you have stepped off the scale and then power off.

NOTE: If the scale is placed on a soft surface such as a carpet or an uneven oor, the results may be inaccurate

or an error message may occur.

Digital Analog Scale Digital Analog Scale

Instruction Manual

SC427SC427

AAA

Kg/lb

Figure 1

Figure 2

Questions and Answers:

General