3.4 Measuring Your Blood Pressure
After the cuff has been appropriately positioned, the measurement can begin:
1. Press the START/STOP button until all the symbols appear on the screen. You will hear 2 short
beeps and after “0” will flash for 2 seconds. The pump then begins to inflate the cuff. The
increasing pressure in the cuff is shown on the display.
2. After the suitable pressure has been reached, the pump stops and the cuff gradually deflates.
The cuff pressure will then be displayed. In case the initial inflation is not sufficient, the device
automatically re-inflates to a high pressure.
3. When the device detects a heartbeat, the heart symbol “
” on the display starts to flash and you
can hear a beep for every heartbeat.
4. When the measurement has been completed, you will hear a long beep and the systolic, diastolic
and pulse rate will appear on the display.
5. The measurement readings remain on the display until you switch off the device. If no button is
pressed, the device switches off itself in 3 minutes.
NOTE: The symbol “ ” will be displayed along with the reading if irregular heartbeat has been
detected during the measurement. If the “ ” symbol appears frequently (e.g. several times a week), it may
be an indication of a more serious heart problem, and you should consult your doctor.
3.5 Discontinuing a Measurement
To stop the measurement (eg. the patient feels unwell) press the START/STOP button. The device will immediately
decrease the cuff pressure automatically.
3.6 Memory Recall
This blood pressure monitor automatically stores 90 measurements for each user in its memory. The oldest record
will be replaced by the latest measurement value when there are more than 90 sets for each user.
3.7 Recall the Memory with the Power Off
Press the “+” or “-” button , the average of the last 3 measurements will be shown, or press the “-” button again
to see the most recent measurement value. Subsequest measurements can be displayed one after the other by
pressing the “+” or “-” button.
3.8 Clear Measurements From Memory
If you are sure that you want to permanently remove all stored memories, press the SET button 7 times until “CL”
appears when the power is off. Press the START/STOP button until “CL” flashes 3 times to clear the memory. After
this, press either the “+” or “-” button, the symbols “ ” and “no” will appear on the screen. This means that the
memory has successfully cleared.
To Next Page
Loading...
