The charger supplied with the scooter charges the batteries based on
the amount of charge present in the batteries (trickle charge) or the
amount discharged by the batteries. When the battery charge is low,
the charger works harder, by sending more electrical current to the
batteries. When the batteries are fully charged the current sent by the
charger is almost zero amperage, in this manner it is very difficult to
over-charge the batteries. Ideally the scooter should be plugged in at
night before going to bed and disconnected in the morning.
Charge the scooter batteries 6–12 hours prior to using it for
the first time
We do not recommend charging the batteries for more than
24 consecutive hours
Charging the Battery
Step 1 - In a dry area, turn OFF the ignition and remove the key
Step 2 - Insert the plug into the charger socket located on the left
side of the steering column
Step 3 - Insert charger extension cord into a wall outlet
Step 4 - Charge the battery for 6-12 hours, depending on the usage
Step 5 - Disconnect the charger extension cord
Step 6 - Insert the key into tiller and check that a full battery charge
has been achieved red/yellow/green = full battery charge.
If the far right, green light bar is flashing, remove the key
and reconnect the charger and continue to charge the
battery
We do not recommend you use any battery charger other
than the one supplied with the scooter
30
To Next Page
Loading...