Biosystem Style 260C User Manual

Style 260C / Style 340C
Laminator with Trimmer
Operating Instructions
Style 260C Style 340C
Technical Data
3.Changing the cutting head
When the blades in the cutting head are damaged or worn, the
cutting head must be replaced.
Note: Only the entire cutting head can be replaced.
3.1 Remove the end cap of the guide rail from the base plate by
pushing it upwards at the lower end at the same time as pushing
it inwards gently.
3.2 Replace the old cutting head with a new one.
3.3 Slide the guide rail back in the device in the base plate and install the new cutting head in the
process
3.4 Place the end cap from above on to the opening at the end of the guide rail.

Biosystem Style 260C Specifications

General

Brand	Biosystem
Model	Style 260C
Category	Laminator
Language	English

Summary

Changing the Cutting Head

Operating Elements

Laminator Operation

Hot Laminating

How to perform hot lamination using the device, including power connection and warm-up.

Cold Laminating

How to perform cold lamination using the device, including setting and foil insertion.

Clearing Jammed Lamination Foil

Steps to clear jammed lamination foil using the ABS switch and cleaning rollers.

Trimmer Operation

Selecting the Type of Cut

How to choose between straight, wave, or perforation cuts on the trimmer head.

Cutting Material

Instructions for cutting paper, card, photos, or foil with the trimmer using guide rail.