To Next PageTo Next Page
Need help?Do you have a question about the BIOTRONIK Enitra 8 HF-T and is the answer not in the manual?
General| Device Type | Implantable Cardioverter Defibrillator (ICD) |
|---|---|
| Manufacturer | BIOTRONIK |
| Maximum Energy Output | 40 J |
| Battery Chemistry | Lithium Silver Vanadium Oxide |
| Remote Monitoring Compatibility | BIOTRONIK Home Monitoring |
| Programming | BIOTRONIK Programmer |
| Bradycardia Pacing Modes | DDD, VVI, DDDR |
| MRI Conditional | Yes |
| Indications | Heart failure |
Procedures that may harm the patient or damage the device.
Risks associated with external defibrillation and radiation therapy.
Risks and precautions for MRI procedures with implanted devices.
Steps for implantation, required parts, and unpacking procedures.
Procedures for checking the device system and monitoring the patient.
Avoiding critical parameter settings and manual sensitivity adjustments.
Measures to prevent device-induced complications, atrial tachycardia, and risks with LV pacing.
Configuration options for timing parameters like basic rate, AV delay, and hystereses.
Settings for ventricular pacing, triggering, and suppression.
Configuration of upper rate limits and mode switching behavior.
Settings for refractory and blanking periods to manage sensing and pacing.
Settings for pulse amplitude, pulse width, sensitivity, and capture control.
Configuration of rate adaptation features like CLS and accelerometer-based modes.
Settings for MRI modes and parameters to ensure safety during MRI scans.
Overview of preset programs and tolerances for parameter values.
Physical dimensions, volume, and mass of the device housing.
Electrical properties, circuit technology, and conductive surface area.
Battery characteristics, power consumption, and estimated service times.
