Accessing the web configuration console
After initial boot up is complete your BirdDog Studio NDI unit will
be visible as a source on any NDI compatible devices on the SAME
ethernet subnet.
For further networking architecture instructions including routing
please consult either your system administrator or the support
page at bird-dog.tv
As BirdDog progresses through its boot-up sequence it will display
“STARTUP”.
Once the boot cycle is complete it will display “CAM1”. At this
point the Web configuration console is available, please type the
following URL into your web browser: http://birddog-xxxxx.local
Where xxxxx is the last 5 digits of the serial
number on the sticker of your device
(case sensitive).
Default password: birddog
BirdDog Studio NDI - REV nº
SERIAL xx:xx:xx:xx:xx:xx
To Next Page
Loading...
