Bisonte BTA-12SDE - Debugging Accelerator Cables and Handlebar; Accelerator Cables Debugging; Handlebar Adjustment and Debugging

1. The up and down debugging for the handle bar connection
① Unscrew the Locked handle of the handle bar connection, and make the terminal tooth
between the handle bar connection and the handle bar base separated.
② Select the best position for the handle bar connection according to your height and likes.
③Thenspin the handle to make the terminal teeth between the handle bar connection and
handle bar base engage well with each other.
2. The left and right debugging for the handle bar connection.
① Unscrew the locknut handle of the handle bar base and the upper and lower terminal teeth.
③ Spin the handle bar left or right to the desired position.
④ Then screw the locknut handle to make the higher and lower terminal teeth of the handle
bar base engage well with each other.
Chapter Six Troubleshooting of Power Tiller
Ⅰ. Troubleshooting of Diesel Engine.
Refer to the instruction manual of diesel engine.
Ⅱ. Troubleshooting of Clutch
(Note: do not dismount the clutch assembly by yourself. Contact our company or our dealers
to shoot the troubles marked with ※
Symptom
Cause
Terms of settlement
The clutch fails
to clutch
Failure of the clutch handle
Repair or replace
Damage of the clutch Cables
Replace
Fork not in the right position
Re-adjust the cable or replace the
fork
Welding points between fork shaft
and arm base break off
Repair or replace
Fork pin is bent or broken
Replace the fork pin
※ Malfunction of the friction piece
Replace
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
103