The friction piece fails to touch the
bearing face of the clutch cover
Add some adjustment pads to the
back of the bearing
Bearing is burnt in the clutch
Replace
Pay attention to refilling engine oil
into the gear-box
Skid around (after loosening the
clutch, the diesel engine runs
normally, but the main shaft of
the transmission shaft stops
running or runs slowly)
※ The spring does not function due
to tiredness
Fork shaft’s failure to turn around
freely makes the fork fail to reset
completely
Clean the combined face between
positioning shaft and pushing plate
to make the fork move freely.
Cable adjustment is not right
Re-adjust the clutch Cables.
Ⅲ. Troubleshooting of Gear-box
Failure of fast, slow and
neutral shift
Bolts and nuts for the main shaft are
loose
Dismount the bolts, keys cover at the
back of the main shaft, screw the round
nuts tight, then fix back the bolts and
keys cover and screw them tight
www.italiastar.ro
info@italiastar.ro
004/021.433.03.27
Italia Star Com Due S.R.L.
To Next Page