AntMiner Manual
Last updated: 11/26/2013
Page 6 of 9
Page 6 / 9
Step 5. Modify the IP address of the WAN interface. Click “Network->Interface->WAN” to modify
the IP address of WAN in the following page.
Note:
1. WAN and LAN can’t be at the same network segment. Please set WAN to DHCP client or
different network segment with WAN. The LAN of new version of antMiner will be set to
DHCP by default.
2. If you set fixed IP to WAN interface, please remember it, otherwise you may not access the
antminer.
To Next Page
Loading...