READ THE FULL MANUAL FOR SAFETY INFORMATION BEFORE FIRST USE
CONNECTING THE AURAL BUDS TO YOUR DEVICE:
Press and hold the power button on the Aural Buds for 3 seconds to power them on
Search for Aural Buds in your device’ Bluetooth list
Put on your favourite tracks
Note: Take care when inserting the charging cable into the charging port on the Aural
Buds. Do not allow the Aural Buds to get wet or expose to high heat. Supervise
children during use.
Power on
There are three buttons on the controller, press and hold the centre button until a blue
light flashes three times.
Power o
Press and hold the centre button for three seconds. You will see a red-light flash to
indicate that the earphones have shutdown.
Pairing
Ensure that the earphones are turned OFF, then press the centre button until you see
red and blue lights flashing. To pair your device (e.g. smartphone/tablet/laptop etc.),
search for and connect to the earphones through the Bluetooth function settings on
your device. The Bluetooth pairing name of the earphones is: BITMORE-BTIE1
Some devices may ask for a password to when attempting to connect to the
earphones, if asked, use: 0000. When pairing is complete, your audio on your device
can be played via the earphones, and you can use the microphone to make calls.
If you have diculty with pairing, please ensure that the earphones are charged,
turned o, and that you are operating the audio and
Bluetooth functions on your device correctly (e.g. smartphone/tablet/laptop etc.).
Repeating the steps in the pairing instructions should resolve most pairing problems.
If this fails, you may also wish to attempt turning your device's Bluetooth function o
and on again and then reattempt the pairing instructions.
BM-IEBTEC AURAL BUDS | 1
AURAL BUDS
UK
To Next Page
Loading...