Go to https://github.com/BitMaker-hub/NerdMiner_v2
Download this repository pressing Code > Download ZIP.
Go to ESPtool online https://espressif.github.io/esptool-js/
Connect your device. Set baudrate 115200 and click connect.
If your device is not listed, try using a different cable.
Select each of the following 4 files previously downloaded
and add each one with his corresponding map address.
You can flash the firmware using 3 methods, the online tool
ESPtool, a Windows concrete tool or the python tool ESPtool.py.
All necessariy files will be found in the src/bin folder of this
project on github. If you want you can compile the entire project
using Arduino, PlatformIO or Expressif IDF.
Standard online procedure
1.
2.
3.
4.
5.
6.Then click program > refer to folowing page
NERDMINERv2
Insert backplate > All ready to flash
0x0000
0x8000
0xe000
0x10000
Bootloader
Partitions
BootApp
Firmware
To Next Page
Loading...