Online ESPtool works with chrome, chromium, brave
ESPtool recommendations: use 115200bps
Build errors > If during firmware download upload stops, it's
recommended to enter the board in boot mode. Unplug
cable, hold right bottom button and then plug cable. Try
programming
In extreme case you can "Erase all flash" on ESPtool to clean
all current configuration before uploading firmware. There
has been cases that experimented Wifi failures until this was
made.
1.
2.
3.
4.
If you can't success send us an email to
bitronics@bitronics.store.
You can also join the NerdMiner Telegram Group where you
could ask for additional support.
NERDMINERv2
After flashing the device, refer to Quick Setup guide to finish
configuration
To Previous Page
Loading...