Labeling
Operating instructions GLP
2 -- 22
6.562.98.5.01.18
2.6 Cancellation and minus
2.6.1 Cancellation via numerator
If a consecutive number is printed out on single labels, incorrectly labeled packa-
ges or packages labeled by mistake may be cancelled via the function ”cancel
via numerator”. This can be done for up to 100 packages, also at a later date.
The cancel function involves all totals active in the labeling procedure. For exam-
ple, in weight class specific labeling, the totals of the relevant weight classes are
also corrected.
After the printout of a total label a cancellation is no longer possi-
ble.
If the operating mode ”(.. print only)” is preset for the single numera-
tor at mode level 5, a cancellation is not possible.
If the operating mode ”piece number article total” is preset for the
single numerator at mode level 5, only packages of the last labeled
article may be cancelled.
Operating sequence: Description
------------------------------------------------------------------------------------------------------------------------------------------------------
[MODE] 1 [ETC]
Cancel.&
minus
Cancel
via nmb.
-- Call up the input menu.
xx [ENTER] --
Enter the consecutive number of label and acknowledge.
The price and weight stored under the consecutive number
entered are subtracted from the totals.
Back <ESC>
OK <ENTER>
Cancel via nmb.: Cancellation could not be carried out
If the above status message appears after input
, one of the fol-
lowing might be the reason:
-- The number entered is not existing.
-- A total label has already been printed.
-- After the input of the consecutive number, more than 100
packages have already been labeled.
In this case:
[ENTER] -- Acknowledge the message.
If the number entered was incorrect, reenter the correct
number and acknowledge. As regards all other causes,a
cancellation is no longer possible.
Notes
If a list printer is connected and a weighing list activated, the consecutive number
and the weight of the cancelled package is printed out on the weighing list with
a minus sign prefixed and the printout is made prominent (see page 5 -- 13).
If the labeler is connected to an EDP, the data of the package cancelled is also
transmitted to the EDP.
2
To Next Page
Loading...
