Options
Operating instructions GLP
5 -- 6
6.562.98.5.01.18
5.3.2 Setting antenna for labels with HF transponders
Depending on the label design the HF transponders can be located on different
areas on the label. You might adjust the antenna on the GLP printing work once
or several times, if different label types are used.
Antenna
Adjustment screw
Please note the following when setting the antenna:
-- Mark the central position of the transponder on the first label on the backing
paper.
-- Put backing paper with label through the open printer mechanism of the printer
until the marked label is above the antenna in the printer.
-- Turn adjustment screw with screwdriver (see picture) until the antenna is in a
central position underneath the marking on the label.
Turn to right: antenna is moved to the right.
Turn to left:: antenna is moved to the left.
5
To Next Page
Loading...
