Additional Installation Tips:
1. If you live in an area that experiences freezing temperatures, be sure to drill an 1/8" hole in the
1 1/4" PVC pipe approximately 6' to 7' below the well adaptor. If you experience freezing
temperatures that could have a frost penetration deeper than 7', drill the hole lower on the 1
1/4" PVC pipe. (See Detail "A")
2. If you experience any deficiencies or malfunction of your Bison Deep Well Hand Pump, please
call 1-800-339-2601 for assistance and answers to your specific questions or concerns.
3. Be sure to check local plumbing codes in your area to be verify that your installation
meets all code requirements.
4. You will notice a handle locking loop is attached to your pump handle along with a stainless
steel chain and hook. If you choose, you can use either a paddle lock or a cable lock to secure
the handle to the pump when not in use. Locking the handle is totally optional.
5. You will also notice that a brass hose bibb cap is shipped with the hose bibb adaptor. This cap
can be tightened to the hose bibb to keep insects out when the pump is not in use. Caution: In
the winter months, be sure to let the pump drain back completely before securing the
brass cap. You may not want to use the cap during the winter.
6. Thank you for investing in a Bison Deep Well Hand Pump.
To Next Page
Loading...