BK Precision 8601 - Page 46

46
Command Syntax
[SOURce:]PROTection:CLEar
Parameters
None
Examples
:PROT:CLE
[SOURce:]INPut:TIMer
These commands enable or disable the electronic load on timer.
Command Syntax
[SOURce:]INPut:TIMer[:STATe] <bool>
Parameters
0 | 1 | OFF | ON
*RST Value
OFF
Examples
INP:TIM 1
Query Syntax
INPut:TIMer[:STATe]?
Returned Parameters
0 | 1
Related Commands
INP:TIM:DEL
[SOURce:]INPut:TIMer:DELay
This command specifies the timer setting.
Command Syntax
[SOURce:]INPut:TIMer <NRf+>
Parameters
1 to 60000s | MINimum | MAXimum | DEFault
Unit
seconds
*RST Value
10
Examples
INP:TIM:DEL 5
Query Syntax
[SOURce:]INPut:TIMer:DELay? [ MINimum | MAXimum |
DEFault ]
Returned Parameters
<NR3>
Related Commands
INP:TIM
[SOURce:]CURRent
This command sets the current that the load will regulate when operating in constant current mode.
Command Syntax
[SOURce:]CURRent[:LEVel][:IMMediate] <NRf+>
Parameters
0 through max rated current
Unit
A (amps)
*RST Value
MINimum
Examples
CURR 5 CURR:LEV 0.5
Query Syntax
[SOURce:]CURRent[:LEVel][:IMMediate]?
Returned Parameters
<NR3>
Related Commands
CURR:RANG