Need help?Do you have a question about the Black & Decker BD-18-DWH and is the answer not in the manual?
Explains safety alert symbols and words used in the manual for hazardous situations.
Alerts about cancer and reproductive harm as per California regulations.
Details requirements for grounding and dedicated circuit breakers for electrical safety.
Specifies intended use and environmental conditions to avoid for the water heater.
Discusses safe temperature settings and the risk of burns, including scald charts.
Specifies conditions to avoid, such as freezing temperatures, moisture, and inaccessibility.
Details required clearances and safety measures regarding flammable materials.
Step-by-step guide for securing the unit, ensuring it is level and upright.
Lists locations and orientations to avoid during mounting, like above electrical boxes.
Advises against soldering with the unit connected and proper pipe connection techniques.
Discusses the recommendation and requirement of a pressure relief valve based on local codes.
Specifies maximum operating pressure and minimum flow rate for optimal performance.
Details the process of flushing lines, connecting inlet/outlet, and purging air.
Emphasizes inspecting for leaks and handling them safely after installation.
Stresses the importance of shutting off power before any electrical work to prevent injury.
Mandates compliance with NEC/CEC for wiring and circuit protection.
Advises verifying sufficient home electrical power for the heater's amperage load.
Step-by-step guide for connecting wires to the breaker and terminal block.
Highlights the need for a ground conductor and double-checking all electrical connections.
Details kW, Max Amps, Required Breaker, and Wire Size for the model.
Visual representation of the electrical connections for the water heater.
Explains on-demand heating, sensor monitoring, flow rate limits, and seasonal variations.
Advises periodic checks for damage, tightening connections, and scale buildup prevention.
Instructions for cleaning the pre-filter and crucial safety steps before maintenance.
Steps to safely resume operation after maintenance, including power cycling and checking temperature.
How to turn the display and the unit on and off using the power button.
Guide to adjusting the desired water temperature using the interface controls.
Information on comfortable temperatures and the recommended setting for household needs.
Steps to take if ambient temperature drops below freezing to prevent damage.
Solutions for problems like power outage, wiring faults, or low flow rate preventing display activation.
Addresses causes for water not being hot enough, like flow rate, voltage, or wiring issues.
Troubleshooting steps for water being too hot or the unit shutting off unexpectedly.
Solutions for issues like water stopping flow or temperature varying between hot and cold.
Details on locating and pressing reset buttons and associated safety warnings.
Procedures for obtaining service, returning the product, and conditions that void the warranty.
General| Brand | Black & Decker |
|---|---|
| Model | BD-18-DWH |
| Power Source | Electric |
| Mounting Type | Wall Mount |
| Thermostat | Adjustable |
To Next Page
