EasyManua.ls Logo

Black & Decker BD2000s - Page 11

Black & Decker BD2000s
125 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
8FSFDPNNFOEUIBUZPVDMFBOUIFEFWJDF
BGUFSFBDIUJNFßOJTIFEVTJOH
- Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that
no water can seep into the device.
8.2 Air filter (B9-10)
In this connection, please also read the
service information.
$MFBOUIFBJSßMUFSBUSFHVMBSJOUFSWBMTBOE
replace it if necessary.
3FNPWFßYJOHCPMUPOUIFBJSßMUFSDPWFS
#
3FNPWFUIFßMUFSFMFNFOUT#
Important!
Do not use abrasive cleaning agents or petrol
to clean the elements.
- Clean the elements by tapping them on a
àBUTVSGBDF*ODBTFTPGTUVCCPSOEJSUßSTU
clean with soapy water, and then rinse with
clear water and air dry.
- Assemble in reverse order.
8.3. Spark plug (B4)
$IFDLUIFTQBSLQMVHJUFNGPSEJSUBOE
grime after 50 hours of operation and if
necessary clean with a copper wire brush.
Thereafter service the spark plug after every
50 hours of operation.
1VMMPGGUIFTQBSLQMVHCPPUXJUIBUXJTU
- Remove the spark plug with the supplied
TQBSLQMVHXSFODI
- Assemble in reverse order.
8.4 Changing the oil and checking the oil level
(B7-8)
The motor oil is best changed when the
Engine is at working temperature.
0OMZVTFNPUPSPJM4"&8
O
C)
<4"&8>
8.4.1 Fill up Oil. (B7)
0QFOUIFPJMßMMFSQMVHCZTDSFXJUPGG
"EEFYBDUMZ-FOHJOFPJMXJUIBOPJMßMMJOH
jug.
0SSFGFSUPDPOUFOUJO
4DSFXUIF0JMßMMFSQMVHCBDL
8.4.2 Checking Oil level. (B8)
1MBDFUIFHFOFSBUPSPOBTMJHIUMZJODMJOFE
surface so that the dip stick is at proper
position.
- Screw off the Oil Filler plug and wipe off
any oil on the dip stick.
1VUUIFPJMEJQTUJDLCBDLXJUIPVUTDSFXJOUP
UIF0JMßMMFS
Important!
Do not screw the dipstick in to check the oil
level; simply insert it up to the thread.
- Check the dip stick; make sure the oil level
JTCFUXFFOo)pBOEo-pNBSL
8.4.3 Let out used Oil (B13)
0QFOUIFPJMßMMFSTDSFXBOEDPOOFDU
UIFESBJOQJQFBOEPJMKVH
- Drain the used oil into a suitable receptacle
by tilting the generator.
8.4.4 Changing Engine Oil
- changing engine oil refers to the content in

Related product manuals