6
Removing the dust bowl and filters (figures E, F, & G)
WARNING: The filters are
re-usable and should be cleaned regularly.
• Press the release latch and pull the dust bowl
straight off.
• While holding the dust bowl over a bin or sink,
pull out the filter to empty the contents of the
bowl.
• To replace the dust bowl, place it back onto the
handle until it “clicks” firmly into position.
WARNING: Never use the
appliance without the filters. Optimum dust collection will only be achieved with clean
filters.
Pre-filter (figure F)
The Pre filter and Pre Filter Housing can be
separated to allow better cleaning.
• Twist the Pre Filter (F1) in a clockwise direction
and lift from the Pre Filter Housing (F2)
Quick clean filter (figure G)
• Lift the filter cleaning handle.
• While holding the quick clean filter housing
(G1), turn the filter cleaning handle (G2) to
perform a quick clean of the filter.
• Pull the filter out of the quick clean filter
housing for more thorough cleaning.
Cleaning the dust bowls and filters
• The dust bowls and filters can be washed in warm soapy water.
• Make sure that the filters and the dust bowl are dry before re-fitting.
E
G
GG11
GG11
F
FF22
FF11
To Next Page
Loading...
Need help?
General
