Black & Decker Cobra User Manual

Repairs, maintenance, and adjustments should be performed by qualified service centers using genuine parts.

One-year warranty against defects in material or workmanship. Return for free replacement or repair.

Product is listed by Underwriters Laboratories to meet stringent safety requirements.

Always wear ANSI Z87-1 and OSHA compliant eye protection when operating the tool.

Tool is designed to be jam-proof, but dirt or damage may cause jams. Clear jams by sliding magazine back.

Instructions for removing and replacing the driver blade and return bumper using correct parts.

Standard method for accurate staple placement. Depress switch, position nose, hold tool, pull trigger.

Method for speed over accuracy. Depress switch, pull trigger, strike nose against work surface to depress yoke.

Comprehensive list of safety precautions to reduce risk of fire, electric shock, and personal injury.

Operator maintenance limits and cleaning steps. Disconnect power, clean magazine and nose. Do not lubricate.

Tool is equipped with grounding plug. Use properly installed and grounded outlets for shock prevention.

Use only 50/60 Hz generators with minimum 1500 watts output. Unit will not operate from a DC generator.

Use UL approved 3-wire cords with proper gauge, suitable for outdoor use if applicable. Inspect cords.

Table listing available staple sizes and corresponding part numbers for 1000 and 5000 staple boxes.