5
ASSEMBLY INSTRUCTIONS
ASSEMBLY TOOLS REQUIRED (NOT SUPPLIED):
- Phillips Screwdriver
ATTACHING BAIL HANDLE TO TRIMMER
WARNING: Only use with handle and guard properly assembled to hedge
trimmer. The use of the hedge trimmer
without the proper guard or handle
provided may result in serious personal
injury.
The trimmer is shipped with the bail handle
tied to the trimmer. To attach the bail handle:
trimmer.
sides of the trimmer housing.
figure A.
tighten securely.
ATTACHING EXTENSION CORD TO TRIMMER
An extension cord retainer is built into
the switch handle that helps prevent the tool from coming unplugged. To use this
feature, first overlap the pigtail cord with the extension cord and tie the two cords in a
knot as shown in figure B. Then, double the extension cord several inches from the
end, and hook the loop formed by doubling the cord over the post in the opening in the
back of the handle area as shown in figure C. Gently tug on the cord to insure that it is
SAVE THESE INSTRUCTIONS FOR FUTURE USE
OPERATING INSTRUCTIONS
TO TURN THE TOOL ON
Pull the LOCK BUTTON (4) back with
your thumb and then squeeze the
TRIGGER (5) with your fingers as
shown in figure D. (Once the tool is
running you can release the LOCK
BUTTON.) To turn the tool OFF, release
the TRIGGER.
A
C
B
D
4
5
To Next Page
Loading...
