Black & Decker HHVI320JR - Nozzle; Accessories

6
clockwise direction.
• Place filters back into the bowl pressing
firmly to ensure a secure fit.
• To replace dust bowl, place it back onto the
handle until it “clicks” firmly into position.
Nozzle / Accessories
(HHVI320JR, HHVI320JRS, and
HHVI325JR)
• Figure L - A crevice tool is built into the
nozzle and can be extended as shown
in figure L by pulling the extension piece
until it locks into position.
L
• Figure M - A brush accessory is built into the
nozzle and can be flipped upwards for use.
M
• Figure N - The nozzle can be rotated for
better access in tight spots. To rotate the
nozzle press the button shown in figure
M and rotate the nozzle to the left or right
until it clicks into place.
N
Assembly Accessories - Figure O
(HHVI315JO)
Your hand vac may be supplied with some
of the following accessories:
• A brush tool for furniture and stairs.
• A crevice tool for conned spaces.
Fitting
• Insert the appropriate accessory into the
front of the appliance as show in Figure O.
• Make sure the accessory is fully pushed in.
O
Scented lter (HHVI320JRS)
BEFORE FIRST USE - remove bag from
the scented pre-filter. Reassemble per
instructions above.
When the vacuum is turned on, the plastic
scented filter will emit an aroma to freshen
the air.
WARNING:
· May cause mild skin irritation. Please
ensure you wear gloves when
handling the scented lter.
· Toxic to aquatic life.
· Harmful to aquatic life with long
lasting effects.
· Avoid release to the environment.
· Dispose of content / container to an
approved waste disposal plant.
NOTE: When the plastic scented filter no
longer lets off the aroma, it can be an indication
that the filter needs to be replaced. See below
for information on replacement filters.
Replacing the lters
The filters should be replaced every 6 to 9
months and whenever worn or damaged.
Replacement filters are available from your
BLACK+DECKER dealer.
Visit www.blackanddecker.com to locate
dealers.
• Remove the old filters as described above.
• Fit the new filters as described above.
Maintenance
Use only mild soap and damp cloth to clean
the vac. Never let any liquid get inside the vac;
never immerse any part of the vac into a liquid.
WARNING: Make sure the vacuum
is completely dry before using it.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.