Need help?Do you have a question about the Black & Decker MM850 and is the answer not in the manual?
General| Type | Electric Lawn Mower |
|---|---|
| Power Source | Corded Electric |
| Voltage | 120V |
| Height Adjustment | Single Lever |
| Mulching | Yes |
| Bagging | Yes |
| Side Discharge | No |
| Warranty | 2 years |
| Amperage | 12A |
| Cutting Width | 19 inches |
| Grass Collection | Rear |
Learn mower controls and proper use for safe operation.
Do not use mower in rain, damp, or explosive atmospheres.
Wear safety glasses or goggles while mowing.
Ensure guards and shields are in place and working.
Repair or replace damaged cords; knot cords to prevent disconnection.
Keep hands/feet away from blade; do not remove cut material with blade moving.
Unplug mower when not in use, before adjustments, servicing, or cleaning.
Keep visitors, especially children, at a safe distance from the work area.
Store mower indoors in a dry, locked place out of children's reach.
Use mower at its designed rate for better and safer performance.
Use the tool only for its intended purpose.
Avoid loose clothing/jewelry; wear rubber gloves and footwear.
Never pull mower by cord; keep cord from heat, oil, and sharp edges.
Use outdoor-suitable extension cords; connect to fused line or circuit breaker.
Maintain proper footing and balance at all times.
Keep blade sharp, clean; inspect cords; keep handles dry.
Ensure switch is off before plugging in.
Clear area of objects before mowing to prevent injuries.
Turn off, unplug, inspect for damage, and repair before restarting.
Always use identical replacement blades for safety and performance.
Use only identical replacement parts when servicing.
Use GFCI protection for circuit/outlet used with lawnmower.
Be thoroughly familiar with controls and proper use of the equipment.
Never allow children to operate the power mower.
Keep the operation area clear of all persons, especially children and pets.
Remove stones, sticks, wires, bones, and other objects before mowing.
Do not operate barefoot or in open sandals; wear substantial footwear.
Never adjust wheel height while the motor is running or mower is plugged in.
Mow only in daylight or in good artificial light.
Never operate in wet grass; maintain good footing and balance.
Do not put hands or feet near or under rotating parts; keep clear of discharge opening.
Release switch to turn mower off when crossing gravel drives, walks, or roads.
Turn off, wait for blade stop, unplug to unclog chute or remove debris.
Turn off, unplug after striking object; inspect for damage and repair.
If mower vibrates abnormally, turn off, unplug, and check for cause.
Turn off and unplug mower whenever leaving it unattended, even briefly.
Ensure blade and moving parts have stopped before cleaning or repairs.
Shut off motor, wait for blade stop, unplug before removing grass catcher or unclogging chute.
Mow across slopes, not up/down; use caution when changing direction.
Never operate without proper guards, plates, or safety devices in place.
Ensure switch is off, blade stopped, and cord unplugged before maintenance.
Check blade at frequent intervals for proper tightness.
Keep all nuts, bolts, and screws tight for safe working condition.
Check grass catcher for wear or deterioration; replace if excessively worn.
Use only outdoor-suitable extension cords with adequate wire size for safety.
Read polarized plug section and orient wide slot with wide blade.
Loop extension cord and push up through the hole in the switch housing.
Pull cord on loop side to remove slack in the switch housing section.
Place loop over strain relief tab and pull cord to secure.
Remove grassbag frame, assembly, and cardboard fillers.
Remove mower from carton and place all four wheels on the ground.
Check carton thoroughly to ensure no loose parts remain.
Raise handle section, secure by tightening the two knobs.
Turn off, unplug mower, and wait for blade to stop before adjusting.
Mower features one touch wheel height adjustment for all four wheels.
Use finger grip to raise or lower height; check scale and pointer for setting.
Insert finger, push lever out, pull back to turn on; release to turn off.
Never attempt to override the operation of this switch.
Shield minimizes throwing of objects; do not operate without it.
Do not operate if rear door is not under spring tension; seek repair.
Do not use mower without grasscatcher or mulch insert in operating position.
Remove all stones, sticks, wire, bones, and other debris before mowing.
Place cord close to outlet, out of mower's path; do not plug in wet.
Begin mowing near outlet, move back and forth, keeping cord on cut lawn.
Mow across slopes, not up/down; use caution when changing direction.
Turn off mower when crossing gravel areas; stones can be thrown by blade.
Set mower at highest cutting height for rough ground or tall weed.
Turn off, unplug, and clean blade area of grass clippings.
Turn off, unplug if mower vibrates abnormally; check for cause.
Always turn off and unplug mower when leaving it unattended.
Mower re-cuts clippings into small pieces that disperse into lawn.
Mower shipped with Mulch Insert installed; see manual for removal.
Keep mower housing free of built-up grass and trash; clean after each use.
Avoid cutting wet grass as it forms clumps and interferes with mulching.
Mow in early afternoon when grass is dried for best results.
Cut only the top third of grass blades; adjust for overgrown grass.
For heavy mulching, make narrower cuts and mow slowly.
Shut off mower, wait for blade stop, unplug mower.
Raise rear discharge door, locate hand in handle pocket, lift and pull out insert.
Repeat steps 1 and 2 for removing mulch insert.
Slide mulch insert into discharge opening until firmly in contact with deck.
Raise rear discharge door to vertical position and hold up.
Lower grass catcher by handle and position hooks on mower.
Never operate unless hooks are seated and door rests against catcher.
Sharpen blade twice per season; more often if lawn has sandy soil.
Replace bent or damaged blade immediately.
Ensure blade is balanced; sharpen at original angle, equal amounts from ends.
Secure blade in vise, wear safety glasses, and carefully file cutting edges.
Check balance by placing center hole over nail/screwdriver; file end that drops.
Release switch, wait for blade stop, unplug mower before proceeding.
Cut 2x4 wood to keep blade from turning while removing blade nut.
Position wood, wear gloves, and remove nut as shown in figure.
Remove lower blade spacer, insulator washer, and blade.
Place insulator washer, spacer, and nut on shaft; align flats.
Position wood to keep shaft from turning, then securely tighten blade nut.
Turn off, let blade stop, and unplug mower before cleaning.
Use mild soap and damp cloth; clean accumulated clippings from deck.
After several uses, check all exposed fasteners for tightness.
Fertilizers/chemicals accelerate corrosion; clean mower after use in such areas.
Wipe all exposed parts with a damp cloth after using chemicals.
Do not pour or spray water on the mower for cleaning.
Do not store mower near fertilizers or chemicals to prevent corrosion.
Repairs, maintenance, and adjustments should be done by qualified service centers.
Full two-year warranty on mower, five-year on plastic deck.
Return product within 30 days for a full refund if not completely satisfied.
Call 1-800-762-6672 for assistance with questions or difficulties.
Accessories are recommended; using others may be hazardous.
MC-1000 is available as a replacement grassbag.
MB-850 is available as a replacement blade.
A complete listing of service centers is included in the manual.
To Next Page