To Next PageTo Next Page
Need help?Do you have a question about the Black & Decker Quantum Pro QP1020LK and is the answer not in the manual?
General| Brand | Black & Decker |
|---|---|
| Model | Quantum Pro QP1020LK |
| Category | Saw |
| Language | English |
Keep work area clean and well lit. Avoid explosive atmospheres and keep bystanders away.
Use polarized plugs, avoid wet conditions, and do not abuse the cord. Double insulation is standard.
Stay alert, dress properly, avoid accidental starting, and use safety equipment.
Secure workpiece, use correct tool, maintain tools, and use recommended accessories.
Keep hands away from cutting area, maintain proper body position, and avoid reaching under work.
Check lower guard for proper closing and free movement. Do not tie it back.
Maintain firm grip, release trigger if binding, restart carefully, and support panels.
Use sharp blades and ensure depth/bevel adjustments are tight to prevent binding.
Minimize dust exposure by working in ventilated areas and using protective gear.
Wear appropriate hearing protection during use to prevent potential hearing loss.
Avoid direct eye exposure, do not aim at others, and use proper safety glasses.
Stay alert, maintain a firm grip, and release the switch immediately if the blade binds.
Support materials, keep blades sharp, use a rip fence, and do not force the tool.
Ensure power supply matches nameplate. This tool operates on AC power only.
Adjust depth knob to set blade projection, typically one tooth below the workpiece.
Adjust bevel angle using the knob and scale, then tighten securely.
Retract guard, assemble blade and washer correctly, and tighten securely.
Operate the trigger switch and align the laser module with the kerf indicator.
Align the laser module with the kerf indicator edge using a straight edge.
Mark the cut line, switch the laser on, and project the beam onto the workpiece.
Insert two AA alkaline batteries, matching the positive and negative terminals.
Align the laser line with the mark and push the saw forward, keeping the line on the mark.
Remove the laser module and use it with a protractor for various applications.
Cut holes without accessing from the side; retract blade guard upwards.
Use a rip fence or guide for ripping; clean the tool with mild soap and water.
Use recommended accessories; the tool is lubricated at the factory.
Locate authorized service centers via the yellow pages or by calling the provided number.
Product is warranted against defects in material/workmanship for two years.
