ENGLISH
BLACKSTONEPRODUCTS.COM/SUPPORT
OWNER’S MANUAL | ASSEMBLY GUIDE
Make sure the front pins are
seated in the holes, then push
the griddle top back.
❶❶
Place the two front pins into
the front locking holes and push
the griddle top back.
❷❷
Then, set the two rear pins
into the rear holes.
❶❶
Place the two front pins into
the front locking holes and push
the griddle top back.
❷❷
Then, set the two rear pins
into the rear holes.
Make sure the front pins are
seated in the holes, then push
the griddle top back.
Make sure the front pins are fully
seated in the holes, then push
the griddle top forward to lock
the griddle in place.
Make sure the front pins are fully
seated in the holes, then push
the griddle top forward to lock
the griddle in place.
MODELS: 2321 • 2321CA
STEP 02
Set the griddle on its feet. Place the griddle top and hood on
the griddle body by aligning the four (4) pins to the holes of the body.
STEP 03
Use the two (2) M6x16 screws pre-installed in the hood
handle to attach the hood handle grommets and the hood handle to
the front of the hood.
STEP 04
Install the two (2) control knobs by pushing them into place
in the OFF position.
STEP 05
Hang the grease cup in the slot on the back of the
griddle body.
To Next Page
Loading...
