1
INSTALLATION MANUAL
BW-1060
SELF-CONTAINED
SECURITY SYSTEM
1
Channel
Before Installing:
1. Read the INSTRUCTIONS!
2. USE A DIGITAL OR ANALOG
VOLT/OHM METER
3. BEFORE MOUNTING THE PRODUCT
CHECK THE POSSIBLE LOCATIONS
FOR THE SIREN AND LED BEFORE
YOU PERMANENTLY INSTALL THEM.
4. PROTECT THE VEHICLE BY USING
FENDER COVERS.
5. ROLL DOWN THE DRIVER’S WIN-
DOW BEFORE STARTING THE INSTAL-
LATION.
6.ALWAYS LOOK BEFORE DRILLING.
MAKE SURE YOU WILL NOT CAUSE
DAMAGE TO VEHICLE HOSES, ELECTRI-
CAL LOOMS OR PHYSICAL DAMAGE
TO VEHICLE.
Timing Information:
Automatic reset time: 45 seconds,
Panic output reset time: 45 seconds,
Arming time: (when all inputs are mon-
itored): 3 seconds-active arm.
Armed output: The Gray wire will pro-
duce a grounded output when system is
armed.
Flashing Parking Light Output:
Armed: 1 second pulsed, Disarmed: 2-one
second pulses.
System triggered: 1 second
pulse on, 1 second off, repeated for 45
seconds.
Input Zone Out Feature:
If a door input remains on for 4 consecu-
tive cycles (45 seconds) that input will be
ignored. If the input returns to a non-trig-
gered state for 30 seconds it will be mon-
itored by the system again.
To Next Page
Need help?
General
