Black Widow BD-PRESS-20H User Manual

Page 1Rev. 061818
DiscountRamps.com • 1-888-651-3431
20 Ton Hydraulic Shop Press
Instructions for Part # BD-PRESS-20H
General Guidelines
• It is the user’s responsibility to read and follow all instructions.
• Keep these instructions with the product at all times and review before each use.
• It is the responsibility of this product’s owner to furnish the instructions to any person that borrows
or purchases the product.
• Inspect the product before use to ensure it is assembled properly and all parts are in safe working
order and free of defects.
• Never modify this product in any way.
• All circumstances cannot be addressed in these instructions. Please use common sense and
practice general safety measures when using this product.
• Parts and/or instructions are subject to change without notice.
Safety
• Steel and other materials can shatter, so always use protective eyewear that complies with the
appropriate ANSI code, a full-face safety shield, and work gloves when operating the press.
• Do not wear loose-tting clothing when operating. Remove ties, watches, rings, and other loose
jewelry and contain long hair.
• Do not use the press when tired or under the inuence of alcohol, drugs, or any intoxicating medi-
cation. Do not allow untrained persons to operate the press.
• If you detect anything that may indicate imminent structural failure, stop using the press immediate-
ly and inspect it thoroughly.
• Only use the press on stable, level, and dry surfaces capable of sustaining the load.
• Bolt the press to the oor it is to be used with bulky or unstable items. If the press will be getting
almost daily use, it is recommended to bolt it down.
• Do not use the press to compress springs or any other item that could disengage and cause a
potential hazard.
• Safe assembly may require two people.
Before Use
During shipment or handling, air in the jack can become trapped in the hydraulic system, causing the
jack to malfunction. To release air from the hydraulic system:
• Turn the release valve counter-clockwise with the handle no more than two full turns.
• Remove the oil ll plug.
• Pump the jack handle quickly in several full strokes.
• Repeat the above steps as needed. Remember to replace the oil ll plug.

Black Widow BD-PRESS-20H Specifications

General

Brand	Black Widow
Model	BD-PRESS-20H
Category	Power Tool
Language	English

Summary

General Guidelines

User Responsibility and Inspection

User must read, follow instructions, and inspect the product before each use for safety.

Operational Safety Precautions

Use protective gear, avoid distractions, operate on stable surfaces, and do not use for hazardous tasks.

Before Use

Hydraulic System Bleeding

Release trapped air in the hydraulic system by manipulating the release valve and handle.

Parts Identification

Component List

Detailed list of all parts with their corresponding descriptions and quantities.

Required Tools

List of tools necessary for assembly and operation.

Assembly Instructions

Frame and Base Assembly

Connect frame sides, base supports, and spreader bar using M12 bolts.

Side Brace Attachment

Secure side braces to base supports and frame sides using M10 bolts.

Jack Ring/Header Mounting

Attach the jack ring/header to the frame sides using M16 bolts.

Press Table Setup

Install support pins and place the press table at the desired height.

Jack Plate and Spring Connection

Connect springs, hook bolts to jack plate, and attach jack plate assembly to springs.

Hydraulic Jack Installation

Fit and secure the hydraulic jack between the jack ring/header and jack plate.

Jack Handle and Valve Operation

Insert jack handle and use it to operate the hydraulic jack's release valve.

Optional Heel Blocks Use

Optional heel blocks can be placed on the press table for added support.

Product Warranty and Liability

General Warranty Terms

Product is warranted against defects in material and workmanship at the time of receipt.

Warranty Service and Limitations

One-year warranty service, exclusions, and limitations on dealer liability.