Black Widow BW 3000 - Advanced Remote Functions; Remote Panic Activation; Silent Arm;Disarm Function; Chirp Delete Configuration

vehicle. The siren will sound, insert your igni-
tion key and turn the ignition to the ON posi-
tion. Then press the Valet/Override Switch,
the system will be overridden and allow you
to start the vehicle.The system will automati-
cally go into valet, so it will not passively
rearm. (See Valet operation to take system out
of Valet mode.)
REMOTE PANIC:
For your personal safety you
may activate the siren by
pressing button #1 on your
remote for 3 seconds.This will
trigger the system into the
Panic mode.The siren will sound and the park-
ing lights will flash (optional).The panic mode
will run for 45 seconds, or until you press but-
ton #1 on your remote again. This feature will
not operate when the ignition is on.
SILENT ARM/DISARM:
If you wish to arm or disarm
your alarm, but do not want
the siren to chirp simply press
button #2 on the remote con-
trol, temporarily deleting the
arm or disarm chirps.
CHIRP DELETE:
To turn
off ARM/
DISARM
chirps,
turn igni-
tion switch on, then press and hold button #2
until you hear a double chirp. The
Arm/Disarm chirps will remain off until you
repeat the procedure.
ENTRY VIOLATION MEMORY:
In the event that your BW 3000 system is
triggered and runs an entire cycle, when you
return to disarm it instead of the usual 2
chirps you will hear 3 chirps, this is to indicate
that the your system was set off., parking
lights will flash 3 times as well (optional).
TEMPORARY TRIGGER AND
SENSOR BYPASS:
If you
would like
to tem-
porarily
arm the
system but only want to have the starter dis-
able engaged (the doors, hood, and or trunk,
and any sensors would not trigger the alarm).
Press button# 1 to arm, then within 5 seconds
press button# 2.You will hear a second confir-
mation chirp to let you know that the system
will NOT monitor the doors, hood, trunk or
sensors.The starter disable function will be
engaged.
TEMPORARY
SENSOR BYPASS:
If you
would like
to arm
the sys-
tem but
want to have it not monitor the shock sensor,
(leaving a pet in the car). Press button #1 to
arm, then within 5 seconds press buttons #
1&2 simultaneously.You will hear a second
chirp to confirm that the sensor will be
bypassed. NOTE: Once you disarm and rearm
the system, the door/hood trigger and sensor
inputs will be monitored
3
3 sec.
+
Press
Press
Press
+
ON
Hold
+
Press
Press